Makita DCL180Z, Instruction Manual, Page: 5 / 12

5
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Disposing of Dust
CAUTION:
•
Empty the cleaner before it becomes too full, or the
suction force weakens.
•
Be sure to empty out the dust inside the cleaner
itself. Failure to do so may cause the filter to be
clogged or the motor to be damaged.
1
2
009992
In order to drop dust sticking on the filter in the capsule,
tap the capsule 4 or 5 times with your hand.
1
2
009993
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
NOTE:
•
Dust may spill out when capsule is opened, so be
sure to set a garbage bag beneath capsule.
1
2
009994
Remove accumulated dust from inside of capsule and off
of prefilter.
1
2
009995
Twist prefilter in direction of arrow to unfasten securing
lip from cleaner unit and then pull off prefilter.
1
2
009996
Clean out fine dust from prefilter. Next, remove filter, and
lightly tap to dislodge dust.
Reassembly
1
009997
Put on filter until it is fully in position on the cleaner unit.
NOTE:
•
Make sure filter is put on straight without being
peeled back. If filter is put on incorrectly as shown
in diagram, dust will get into motor housing, and
cause motor failure.
1
010005
1. Filter
1. Prefilter
1. Prefilter
2. Filter
1. Prefilter
2. Securing lip
1. Prefilter
2. Capsule
1. Capsule
2. Suction inlet
1. Suction inlet
2. Capsule