Makita BTP140, Instruction Manual

Page: 9 / 16

9
For other countries
1. To install the bit, pull the sleeve in the direction of the arrow and insert
the bit into the sleeve as far as it will go. Then release the sleeve to
secure the bit.
2. To install the bit, pull the sleeve in the direction of the arrow and insert
the bit-piece and bit into the sleeve as far as it will go. The bit-piece
should be inserted into the sleeve with its pointed end facing in. Then
release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit
out firmly.
NOTE:
• If the bit is not inserted deep enough into the sleeve, the sleeve will not
return to its original position and the bit will not be secured. In this case,
try re-inserting the bit according to the instructions above.
Hook (Accessory)
CAUTION:
• When installing the hook, tighten the screw firmly. Failure to do so may
cause the breakage of the tool or personal injury.
The hook is convenient for temporarily hanging the tool. This can be installed
on either side of the tool.
To install the hook, insert it into a groove in the tool housing on either side and
then secure it with a screw. To remove, loosen the screw and then take it out.
To install these types of bits, follow
the procedure (1).
(Note) Makita bits are these types.
To install these types of bits, follow
the procedure (2).
(Note) Bit-piece is necessary for
installing the bit.
A=17mm
B=14mm
A=12mm
B=9mm
006349
1. Bit
2. Sleeve
1 2
001267
1. Bit
2. Bit-piece
3. Sleeve
1 2 3
004347
1. Hook
2. Screw
3. Groove
2
3
1
006251