8
For LED#B
1
2
007917
Led indicator / Beeper on the tool shows the following
functions.
Green
Red
lights up
when the tool is connected to a receiver.
blinks
when the tool is on the step of being connected to a
receiver. (Note 1)
is turned off
one of the status below
when the battery cartridge is removed from the tool.
when the tool is left idle for more than 15 minutes
with a installed battery cartridge.
when the tool is not within the transmission
distance. (Note 2)
lights up
when the tool's stored number of data reaches its
storable number of data.
when the tool's stored number of data is equal to or
smaller than its storable number of data.
when the tool has no stored data to transmit to a
receiver.
Description
Viewed color
View and status
1
2
3
blinks
is turned off
1
2
3
3-1
3-2
3-3
LED#B
LED#B
007929
Note 1: Refer to a instruction manual of receiver
(accessory) RCV02 when connecting it.
Note 2: Communication distance: 10 m or less (variable
up to 10 m depending on the operation environment)
CAUTION:
•
Make sure that LED#B
②
does not light up before
removing a battery cartridge from the tool. If a
battery cartridge is removed while LED#B
②
lights
up or blinks, tools stored data will be deleted.
Adjusting the fastening torque
1
2
007920
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1.
First remove the battery cartridge from the tool.
2.
Loosen and remove the screw that secures ring.
3.
Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4.
Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.
1. Adjusting ring
2. Ring
1. LED#B1
2. LED#B2