![background image](http://html.mh-extra.com/html/makita/an451/an451_instruction-manual_228631004.webp)
4
ENGLISH (Original instructions)
Explanation of general view
3-1. Pneumatic tool oil
4-1. Arrow
4-2. Adjuster
4-3. Knob
5-1. Contact element
5-2. Shingle guide
5-3. Shingle
5-4. Projection
6-1. Adjusting plate
6-2. Lever
7-1. Latch lever
7-2. Magazine cap
8-1. Graduation
8-2. Arrow
8-3. Coil support plate
9-1. Feed Claw
10-1. Air fitting
10-2. Air socket
11-1. Trigger
11-2. Contact element
13-1. Small rod
13-2. Ejection port
14-1. knob
14-2. Adjuster
14-3. Contact element
15-1. Brush
15-2. Ejection port
19-1. Drain cock
20-1. Air filter
21-1. Oiler
21-2. Pneumatic oil
SPECIFICATIONS
Model AN451
Air pressure
0.44 - 0.83 Mpa (4.4 - 8.3 bar)
Nail length
22 mm - 45 mm
Nail capacity
120 pcs.
Min. hose diameter
6.5 mm
Pneumatic tool oil
Turbine oil
Dimensions (L X H X W)
245 mm X 265 mm X 114 mm
Net weight
2.5 kg
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END106-3
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
・
Read instruction manual.
・
Wear
safety
glasses.
・
Do not use on scaffoldings, ladders.
ENE059-1
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 “x 4” housing.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
pA
) : 87 dB(A)
Sound power level (L
WA
) : 100 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG904-2
Vibration
The vibration total value determined according to EN792:
Vibration emission (a
h
) : 3.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
•
The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
•
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
Summary of Contents for AN451
Page 58: ...58 ...
Page 59: ...59 ...
Page 60: ...60 Makita Corporation Anjo Aichi Japan www makita com 883862A984 ...