Mounting Plate and Motor Attachment
(1)
Mounting Plate
(1)
Belt Clamp (nuts pressed in)
(1)
Metal Motor Mount with ECB
(2)
M3x10 flathead screws
(4)
M3x18 flathead screws
(5)
M3x12 socket head screws
•
Place belt clamp on front belt span with fin toward the
rear.
•
Place the extruder mounting plate on top of the belt
clamp and X rail carriage with the slot of the clamp
facing towards the Z-knob on the top left of the machine.
Insert (4) M3x18 screws through the back four holes
of the mounting plate to secure the belt clamp. Tighten.
•
Insert (2) M3x10 screws through the two rearmost re
maining holes to tighten the mounting plate to the X rail
carriage.
•
Place the Motor Mount on top of the mounting plate
with the printed ECB facing the rear. Insert (2) M3x12
screws and tighten while pulling the Motor Mount to the
front.
•
Noting the location of the connector, remove the three
m3 bolts that have been removed from the corners in
the picture to the right using a 2.5 mm wrench.
•
Place the motor through in the Motor Mount with the
wire connector facing right. After making sure the motor
is slid all the way into the motor mount, tighten the (3)
M3x12 screws to secure the motor.