Removing the extruder harness
• Cut and remove the zip ties that secure the extruder harness
to the printer
• Please review the comparison photo. Your harness should
look like the top harness and you’ll need to adjust it to
look like the bottom harness
• Snip the cable ties that hold the cables inside of the braided
wiring loom
Step 3: Wiring harness adjustment and installation
5
Adjusting the extruder harness
• Pull the wires through the harness so there is only
1”
of each
wire sticking out of the loom
• Pull the wire with the white connector in the loom all the way
to the end
• Reapply cable ties to the harness
• Plug the white connector into the extruder motor through the
wiring box
•
Install the wiring box lid with a 2mm allen wrench. This takes
a little torque as the screws are tapping themseleves into
the printed part
