02
03
mBot Add-on Pack Contents (1:1)
M2 Nut
M4 Nut
M2.2×6.5mm Self-drilling Screw
M2.2×8mm Self-drilling Screw
M2×10mm Screw
M4×8mm Screw
Servo Arm
M4×25mm Brass Stud
Any unknown parts can be checked here.
Construction Knowledge for the add-on pack
1. Adjust servo
You need to adjust the servo in order to make it rotate to a certain
angle as precisely as you want. You can adjust it with mBlock,
mBlockly and MakeBlock in three steps, as follow:
1.1 Wire connections
Befor adjusting servo, you need to prepare mCore, RJ25 adapter
module and the servo to be adjusted. Connect the wires as follows.
Connect RJ25 adapter module to the Port4 of mCore and connect
servo to the slot2 of RJ25 adapter module.
1.2 Adjust servo with software
①
Adjust servo with mBlockly
Firstly, you should connect mBlockly to your mCore, then develop
program as follow. After that, click "Go" to see the servo automatically
rotate to 90°.
Unit: millimeter (mm)
Summary of Contents for mBot Servo Pack
Page 14: ...24...
