45"5&1BHFT DPOU
2
6
(MPCBM4FUUJOHT
When in the State Pages, press
C/Orange
to enter the Global Page. The bottom row of the CV Programming Grid is used here:
GBL.Z.ON: When set to be ON (Green), Z-MOD and Z-CV will be active and select States at all times. PGM pages can be edited even while
States are being sequenced/selected. LATCH pages are not per-State, so Latch playing can be used to play and alter a series of States in a
non-destructive fashion. When set to be OFF (button not lit), Z-MOD and Z-CV only work on the State Select Page.
Note: If you are advancing quickly through States using Z-MOD and/or Z-CV, and you have Z.ON enabled, it
may
be challenging to
program with precision. If you desire precise deliberate programming, disable Z.ON or manually advance through States (use a manual
gate from Pressure Points) while programming with Z.ON enabled.
GBL.Z.RESET: When set to
be ON (Green)
, Z-MOD selects a new State as normal, but also resets
X
,
Y
, and
C
Channels to the ACCESS-
enabled location that is nearest to Location 1.
The same applies to manual State selection on the State Select Page: with Z.RESET on, pressing any enabled location (including the
already-current State) resets all three Channels.
Z.RESET is one way to create a chain of “sequences” with known start points. However, in many cases it is more powerful to leave
Z.RESET OFF, because this allows the Z Axis to represent a third dimension of sequencing that does not interrupt the X and Y axes. In
fact, considering the multiple channels and FUN options per axis, René with Z.RESET OFF is less a 3-dimensional cube than an n-
dimensional matrix, or tesseract.
If Z.RESET is ON and Z.ON is OFF, then Z-MOD can also be used in the Program Pages to Reset all three Channels, without changing
State, or needing to use FUN.MOD.RESET.
GBL.BUS: sets Select Bus Behavior (see p. 28 for general information about the Select Bus
)
. OFF=Free,
Red=Lead
,
Green=Follow
.
LEAD
active means that René transmits messages on the Select Bus so that other compliant modules (such as the Make Noise TEMPI with
latest version
installed),
if they are
set to FOLLOW, can do any of the following actions simultaneously with the René:
- Change Bank/State
- Multi-Paste States
- Mesh States
- Store
Note: To set TEMPI to FOLLOW, double-press PGM_
A
to enter the Bank Edit Page, then press BUTTON3 to turn the TEMPO LED GREEN
to indicate that TEMPI is FOLLOWing.
FOLLOW
active means that René will change State to match the current command on the Select Bus. Use one René to lead another via
the State Select Page, for example.
FREE active means that René ignores the Select Bus, and does not transmit information on it. Use this option if you are not using the
Select Bus, or if you have other modules that use the Bus for different purposes (such as Doepfer modules that use it for CV/Gate).
FREE is the default for GBL.BUS.
