9
IMPORTANT: These small holes should be at the same side of each
bar of the top frame. If they are not all on the same side, the legs will not properly attach to the top
frame of the t-top. It may appear a half inch too short when attaching the legs. If this is the case,
check the holes again.
STEP 6: Attaching the Side Supports to the Assembled Top Section
Check the direction of the side support arms: the logo to the outside, the
handle to the rear. The small curved top frame for the cover curves and
bends downward to the floor. Remove the tops of the ball clamps and use
the rubber inserts inside the clamps for a tight connection. Note: The
clamps are to be placed on the same way (they are numbered inside).