- 4 -
To Receive
1 Turn the unit on by rotating the Volume control clockwise. Continue to rotate the knob in the same
direction to increase the loudness.
2 Turn the Squelch control anti-clockwise, then slowly clockwise until the hissing sounds just stop. It is
important to set this control carefully. When properly set, annoying static noise (hiss) will be eliminated
while allowing reception of weak signals. Turning the Squelch control too far clockwise increases the
signal required to actuate the receiver and may prevent reception of weaker signals. Turning the control
too far anti-clockwise will allow the receiver to pick-up atmospheric noise and objectionable background
hiss.
3 Select the required frequency band using the Hi-Lo Switches (See “Controls and Functions” for
details).:
4 Turn the channel selector to any the forty channels.
5 Set the Mode switch to “AM”, “FM”, “LSB” or “USB”.
NOTE: When using the UK FM (CB 27/81) Band, the Mode must be set to “FM”.
When using LSB and USB, adjust the Clarifier to obtain the most pleasing (normal) range of voice tones.
Varying this control to either extreme varies the tone of the voice from a high pitch to a barely
intelligible low tone.
To Transmit
1.
Plug the microphone cord into the MIC jack.
2. Wait until the channel you selected is clear.
3. Hold the microphone directly in front of you at a distance, of 2 or 3 inches. Press the microphone's
pushbutton and talk in a normal voice to transmit your message.
Note: To avoid garbled transmissions, do not shout into the microphone or hold the mic too close to
your mouth.
Release the microphone's pushbutton to receive.
Operating Instructions
