12
2. Insert the black test lead banana plug into the negative
COM
jack.
Insert the red test lead banana plug into the positive
V
jack.
4.7. Temperature Measurements
1. Set the function switch to
TEMP.
4.6. Frequency or % Duty Cycle Measurements
1. Set the rotary function switch to the
“VAC/Hz/%”
position.
1. Set the rotary function switch to the
Ω
CAP
position.
3. Press the
MODE / INRUSH
button to change to capacitance
measurements.
WARNING:
To avoid electric shock, disconnect power to the unit under
test and discharge all capacitors before taking any capacitance
measurements. Remove the batteries and unplug the line cords.
3. Select
Hz
or
%
duty with the
MODE / INRUSH
button.
4.5. Capacitance Measurements
5. Read the capacitance value in the display.
2. Insert the black lead banana plug into the negative
COM
jack and the
red test lead banana plug into the positive
V
jack.
4. Touch the test probe tips to the circuit under test.
4. Touch the test leads to the capacitor to be tested.
5. Read the frequency on the display.
WARNING:
To avoid electric shock, disconnect both test probes from
any source of voltage before making a temperature measurement.
2. Insert the Temperature Probe into the negative
COM
and the
V
jacks,
making sure to observe the correct polarity.
3. Touch the Temperature Probe head to the part whose temperature you
wish to measure. Keep the probe touching the part under test until the
reading stabilizes (about 30 seconds).
4. Read the temperature in the display. The digital reading will indicate the
proper decimal point and value.
WARNING:
To avoid electric shock, be sure the thermocouple has been
removed before changing to another measurement function.
