P. 3
QUICK SETUP
STEP 1:
Plug in the enclosed AC/DC adaptor to an AC wall outlet and then the DC jack to the back of your weather station.
STEP 2
:
Keep your weather station and wireless outdoor transmitter next to each other. Slide open the battery cover at the back of
your wireless outdoor transmitter, then insert 2 x AAA new alkaline batteries to the battery compartment. Make sure the
Channel selector switch is at
1
position. Replace the battery cover.
Your weather station will receive data signal from the outdoor transmitter in few seconds. Then place your outdoor transmitter
in a dry and shaded area.
STEP 3:
The weather station computes weather forecasts based on changes in pressure sensor. However, when using the weather
station for the first time, it may take up to a few days of collecting sufficient information for more accurate forecasts.
Manual setting of the weather forecast can slightly accelerate this process.
Please refer to “
TO SET THE WEATHER STATION
“ Step 9”.
TO POWER UP THE CLOCK
Plug in the AC/DC adaptor to an AC household outlet, and then plug the DC jack to the lower right back of the unit. Your unit
is ready to work for you.
TO INSTALL BACKUP BATTERIES
Your weather station requires 2 x new AA batteries (not included) to provide backup power to it in the event of a temporary
power interruption.
1.
Place your weather station face down on a flat and soft surface.
2.
Slide and remove the battery cover at the back of your unit.
3.
Insert 2 x new AA batteries into the battery compartment by observing the correct “+” and “-“ polarity.
4. Slide and replace the battery cover.
Remarks:
Do not mix old and new batteries.
Do not mix alkaline, standard or rechargeable batteries.
Alkaline batteries are recommended for optimal usage of this clock.
If AC power is interrupted, the backlight can light 8 seconds, by pressed Snooze button, alarm can work, but projection does
not function when only backup batteries are used to power your unit. The backup batteries will keep all settings of your unit.
