54
Majestic • ECHEL36IN/STIN, ECHEL48IN/STIN, ECHEL60IN, ECHEL72IN Installation Manual • 2406-970 Rev. C • 1/17
Non-Combustible Finish Materials
NOTICE:
This four inch maximum not only includes the
decorative
fi
nish materials (marble, tile, slate, etc) but also
the thin set, lath and adhesive used to attach the decorative
fi
nish material
.
Note:
When a Clean Face Trim decorative front is
installed, the rectangular holes in bottom access panel
will be covered.
Clean Face Trim Front (CFT)
Inside Fit (1-4 Inches Thick Finishing Method)
There are two options for this method of
fi
nishing:
With Decorative Trim Ring: (Option #2)
The trim ring, which is included with the CFT front, will be
installed and used as a
fi
nishing template. It will be left
exposed.
WARNING! Risk of Fire! DO NOT
apply
fi
nishing mate-
rial beyond the trim ring. Appliance will overheat if
fi
nish-
ing material extends into appliance opening.
1. Verify that factory-installed
fi
nishing guards are in-
stalled to ensure
fi
nishing material does not extend into
the
fi
replace opening. See Figure 10.2 and Figure 10.3.
2. The non-combustible
fi
nish material, 1-4 inches thick,
should be installed up to the
fi
replace opening on all
four sides, including the bottom access panel, cover-
ing the rectangular holes. Refer to Figure 10.4.
WARNING! Risk of Fire! DO NOT
apply
fi
nishing mate-
rial beyond the
fi
nishing guard. Appliance will overheat if
fi
nishing material extends into appliance opening.
NOTICE:
Decorative front will not
fi
t properly if
fi
nishing
material is applied beyond the
fi
nishing guard.
3. Follow Inside Fit section of the instructions provided
with decorative front.
1. Remove top and bottom
fi
nishing guards.
2. Install trim ring (included with CFT decorative front).
Push trim ring completely into the opening.
3. Place trim ring into position and install the four shoul-
der bolts through the trim ring as shown in Figure 10.6.
Install the screw as shown in Figure 10.5.
Finishing materials may be installed up to the trim ring but
must not extend beyond it. See Figure 10.7.
Figure 10.5. Install Trim Ring
Figure 10.6. Install Shoulder Bolts
BOTTOM GLASS SHIELD
SHOULDER
BOLTS (4)
RECTANGULAR HOLE
BOTTOM PANEL
WARNING! Risk of Fire! DO NOT
apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as speci
fi
ed in
this manual. Overlapping materials could ignite.
NOTICE:
It is recommended that high temperature silicone
sealant (500º F minimum continuous exposure rating) be
used to adhere the trim ring to the
fi
nishing material.
Without Decorative Trim Ring: (Option #1)
Note:
You will not use the trim ring, which is shipped with
the CFT front, for this application.
CFT Finishing Method
Trim Ring
Inside Fit
Included & Not Used
(Option #1)
Included & Used
(Option #2)