8
Majestic • CK36MS Contemporary Kit Instructions • 2488-970 Rev. D • 7/18
Install Stones Kit
19. Place stone jig on burner by setting it onto the media
with the “STONE JIG” facing up and on the pilot side
of the base pan. See Figure 21. Slide it toward the
pilot shield/rock stop until the rock stop is flush with
the stone jig inside the rectangular notch. See Figure
22.
20. Place stones in a random manner in the open spots
on the base pan. Remove stone jig. Do not discard
Consumer:
Retain jig for future maintenance or service
needs.
Figure 21. Stone Jig
WARNING
Delayed Ignition Risk
• Place stones according to instructions.
• Do NOT place stones in a position that they may
fall into area in front of pilot.
• Do NOT use any stones other than the stones
supplied with this fireplace.
• Do NOT stack stones.
Fireplace will not function properly.
Delayed ignition may occur.
Figure 22. Rock Stop and Stone Jig
Note:
A tall, deep orange flame should be avoided; this
type of flame may cause increased soot residue. If you
notice a tall, deep orange flame, try adjusting the media
directly beneath the flame. If all flames appear to be
tall and deep orange in color, then open the primary air
shutter.
21. Remove rock stop by removing 1 screw.
22. The IFT control module must be set to 30% turn
down. Switch the module to OFF. Locate the turn
down selector switch on the top of the control module.
Remove the rubber plug. Using a small screwdriver,
slide the selector switch to 30. Switch the module
back to REMOTE. See Figure 23.
Air Shutter Settings
NG
FULLY CLOSED
PROPANE
FULLY OPEN
Table 1.
Figure 23. 30% Turndown on Module
TURN DOWN
SELECTOR SWITCH
23. Adjust shutter as noted in Table 1.
Note:
If the turndown percentage is changed while
the module is in the ON or REMOTE setting, it will not
recognize that the change has occurred. If this happens,
the module must be switched to OFF and then back to
REMOTE for it to recognize the change.
