MCVC
DIY Manual
©2019 Majella Audio
7
Minijacks (17x)
Take care on this one!
We advice to (without soldering) place the
jacks into the PCB (yellow marked, figure 4).
Then place the panel on the jacks. Carefully
turn around the MCVC and lay it down on
supports, as shown below in figure 5:
Figure 5:
support
Solder one pin from each connector. Make
sure to press the panel so that each
minijack connector is tight pressed to the
PCB when soldering the pin. Check if all
minijacks fit tight between the panel and
PCB. Then solder the rest of the pins.
Figure 4:
3.5 mm minijacks (YELLOW)
