Hardened Gigabit High Power PoE Injector
Wuhan Maiwe Communication Co., Ltd
Tel: 027-87170215/16 Fax: 027-87170217
Add: No.52 Liufang Avenue, East lake High-tech Development Zone, Wuhan, China
3
V1.0
Setup
a) Connect the Ethernet port of the injector to a LAN switch with a network cable.
b) Connect the PoE Out port to the PoE device
c) After the device is powered on, the PWR indicator will all be on. If the indicators are not on, check the
power supply connection.
d) After all cables are correctly connected, the indicators will be lit as per port status LEDs (page 3)..
Interface
Ethernet/PoE Out Port
RJ-45 Pin Assignment
Pin
Ethernet
PoE Out
1
TP0+
TP0+
2
TP0-
TP0-
3
TP1+
TP1+
4
TP2+
TP2+/VCC+
5
TP2-
TP2-/VCC+
6
TP1-
TP1-
7
TP3+
TP3+/VCC-
8
TP3-
TP3-/VCC-
Power Connection
：
Pin
Description
-
+
Power Input
GND
+12-48V
(DC)
Cable Connections
Signal Type
Cable Type
Connector
Ethernet
Cat. 5 or above
RJ45
1. Tighten the screws to fix the
Wall Mount plate
2. Mount the switch on the wall or
on a flat surface with 2 screws
piercing through the mounting
holes to secure it in position.
