S12800 Routing Switch Installa
tion Manual V1.0
Maipu Confidential & Proprietary Information
Page 21
2.3 Open-Package and Inspection
When delivering S12800 routing switch, adopt the carton to packet some card or module
separately according to the configuration purchased by the user. Please inspect according to
the following steps:
Step 1:
View the carton label and confirm the card or module model.
Step 2:
Use a paper knife to gash the tape along the lid commissure; be careful when
using the knife; do not insert too deep, avoiding damaging equipment inside.
Step 3:
Open the carton, and take out of the protection EPE.
Step 4:
Check the card type and quantity in the carton according to the packing list.
Step 5:
Wear an antistatic wrist, open the anti-static bag, take out the board, and check
whether the board has the obvious damage (including whether the backplane
connector pin/hole is deformed, whether the heat sink falls off and so on).
2.4 Wooden Box Open-package
The shelf of S12800 routing switch adopts the wooden packaging. The packaging of one shelf
comprises the wooden box, plastic bags, protection EPE and other packaging materials. Before
opening the box, move the packing box to the equipment room or near to the equipment room
(if the space permits), so as to avoid damaging the shelf when moving.
Wooden box has direction and cannot be placed inverted. Otherwise, it will cause fatal
damage for the product.
When handling and opening the wooden box, it needs two or more persons to cooperate.
The wooden box adopts the alligator clip to fix. When opening the wooden box, you need
to use the dedicated tools for removing the alligator clip to operate.
Step 1:
Wear the gloves.
Step 2:
Place the wooden box flat on the ground. The wooden box has direction and
cannot be placed inverted.
Step 3:
Remove the opener.
