Mainstreet Equipment 541CG1N, User Manual

Page: 15 / 34

15 Mainstreet Equipment
User Manual
OPERATIONAL INSTRUCTIONS & WORK FLOW
LIGHTING, RELIGHTING, AND SHUTDOWN INSTRUCTIONS:
1.
oven is equipped with a direct hot surface ignition system. There is no pilot to light.
2.
to allow the gas that was released to dissipate, and try to light the burners again. If the burners still fail to
ignite after three such attempts, the oven will stop trying, even though the power switch is in the “ON”
position. To continue to attempt to light the burners, turn the power switch “OFF” and then “ON” again.
3.
control panel and remove the right side panel. Turn the manual electric and gas valve to the “OFF” position.
Re-attach the right side panel.
SAFETY PRECAUTIONS
CAUTION:
Potential hazard or unsafe practice could result in minor or moderate injury or product or property
damage.
NOTICE:
• Local codes regarding installation vary greatly from one area to another. The National Fire Protection
Association, Inc., states in its NFPA96 latest edition that local codes are “Authority Having Jurisdiction” when it
comes to requirement for installation of equipment. Therefore, installation should comply with all local codes.
• This product is intended for commercial use only. Not for residential use.
WARNING:
•
equipment.
• Improper installation, adjustment, alteration, service or maintenance could lead to property damage, injury or
death. Read the installation, operating and maintenance instructions thoroughly before installing or servicing
CPG equipment. This manual must be retained for future reference.
• Instructions must be posted in a prominent location. All safety precautions must be taken in the event the user
smells gas. Safety information can be obtained from your local gas supplier.
• A factory authorized agent should handle all maintenance and repair. Prior to conducting any maintenance or
repair work contact an authorized service agency.
GAS PRESSURE:
supply piping system during any pressure testing of that system at test pressures in excess of ½ PSI (3.45 kPa). The
during any pressure testing of the gas supply piping system at test pressures equal to or less than
½ PSI (3.45 kPa).