MAINE ENERGY SYSTEMS AutoPellet Air TOUCH 17, Installation Manual

Page: 22 / 76

22 Bringing the pellet Furnace into the Furnace room
7 7
Bringing the pellet Furnace into the Furnace
room
This section describes the prerequisites as well as the working sequence required.
1. Transport
2. Notes on bringing the unit into the building
3. Casing parts
4. Dismantling the casing parts
7.1 Transport
We supply the pellet Furnace on a pallet. The pellet Furnace is ready to be connected.
The control unit for the Furnace controller and the operating drvice is integrated into the control panel.
If it is not possible to bring the Furnace into the building at ground level, then you can remove the casing, the
burner, the hopper and the Furnace controller. This will reduce the weight of the unit and make it easier to
carry.
C Co on ntta am miin na attiio on n a an nd d c co orrrro ossiio on n
Make sure that the pellet Furnace is located under a roof
if it needs to be stored outside before it is transported/
brought into the building. It is also necessary to trans-
port the Furnace in a closed in truck or trailer. Furnaces
transported otherwise will lose their warranty.
7.2 Notes on bringing the unit into the building
Before bringing the unit into the building, check the dimensions of all doors to ensure that the Furnace has
sufficient clearance and can be set up properly.
Minimum door width – max. unit dimension
Furnace
25, 32 kW 29.53 inch
Furnace dimensions
PE 603 USA_FA 1.0