DVR operation manual
10
2)
Don’t touch the device with wet hands.
4
、
Installation site
1) In order to prolong device service life, the equipment install on the vehicle vibration
weaker parts possibly, such as the rear of the driver's seat;
2) The device should be installed in the vehicle ventilated area
3) External wire of the device shoule has enough interval and the protection of coat
flame tube,to make sure that the cable is not bent or wear and leakage which because of
vibration
4) Ensure that the device on the vehicle away from the heat source, the device can
not have debris piled up around the prohibited place any objects on the device.
5) Far as possible from electromagnetic complex environment, away from strong
interference environment
5
、
device security
1) Ensure passenger or driver can not interfere and damage any part of the device
2) When installing device, powered vehicles may cause damage of the device, be
sure the vehicle is stationary during the installation process, avoiding device falling down
3.2 Access power
1
、
Power cord material:depending on the device and host maximum load
requirements, select wire diameter cord requires 1.5MM-2.5MM, using BVV wiret
to ensure that the wires are not frayed.
2
、
Host power access methods: It is recommended to take from the battery positive
and negative electricity alone.
3
、
Device power cord with other lines should be vertical alignment to avoiding
synthetic interference
4
、
Power cord adapter connector use solid way possibly, and to avoid pulling stretch
work.
5
、
Line alignment requirements, location is convenient to gather route ,hidden beauty,
all the lines plus protective sleeve.
