INSTRUCTION MANUAL FOR DISHWASHERS
Page 8 of 14
UK
4.7
Automatic cycle start-up
This function is used to make the chosen cycle start automatically when the door is closed. To enable,
proceed as follows (
Fig.6
):
•
With the appliance on and the door open, press and hold (for at least five seconds)
START
(3)
until
AS
appears on the display
.
•
To disable the function, with the door open press
START
(3)
again for five seconds.
4.8
Removing the integral filter
•
Move the washing and rinsing arms at right angles to the edge of the door (
Fig.7
).
•
Lift each semi-filter by the relative handle.
4.9
Emptying the dishwasher
4.9.1 Appliances with no drain pump
•
Switch the dishwasher off.
•
Remove the integral filter (
Fig.7A
).
•
Pull up and remove the overflow pipe
( Fig.8B
).
•
Wait for the tub to empty completely.
•
If necessary, extract the tub filter and clean (
Fig.8C
).
4.9.2 Appliances with drain cycle (*optional)
•
If present, remove the integral filter (
Fig.7
).
•
If present, remove the overflow by pulling upwards (
Fig. 9
).
•
Close the door.
•
Select the cycle
dr
•
Press
START (3)
to start the cycle.
•
The machine runs a drain cycle with self-cleaning (*where foreseen) and then switches off.
•
If necessary, extract the tub filter and clean (
Fig.8C
).
4.10
Turning the dishwasher off
•
Press
ON/OFF (1)
, on the
DISPLAY (4)
the central segments will light up, indicating that the
machine is powered.
4.11
Resin regeneration (*optional)
I
n machines fitted with water softener, when the warning
‘SALt’
appears you should add salt to the
relative container; proceed as follows:
•
Remove the basket from the machine.
•
Remove the integral filter (
Fig. 7
).
•
Unscrew the cap on the salt container (
Fig. 11
).
•
Pour in approx. 700g of large-grain kitchen salt, using the funnel supplied. (when filling for the first
time, fill the tank firstly with water)
•
Close the container firmly.
