INSTRUCTION MANUAL FOR DISHWASHERS
Page 7 of 14
UK
Chap 4
USING THE MACHINE
4.1
Key and symbols
Referring to
Fig.1
:
1 ON/OFF
BUTTON
5
INFORMATION
DISPLAY
2 SPECIAL PROGRAMME SELECTION
BUTTON
6 STATUS BAR
(LED)
3 PROGRAMME SELECTION
BUTTON
7 CHECK BAR
(LED)
4 START
BUTTON
4.2
Switching the dishwasher on
Referring to
Fig.2
:
Turn on the main power switch and open the external water tap.
Check that an overflow is present, if required.
Press
ON/OFF (1)
.
The
CHECK BAR (7)
lights up, turning from red to green to confirm the check. In the event of a
serious fault, the led bar lights up in red and stops the machine operation; a minor error is indicated
in orange, and will not stop the machine cycle.
Loading begins automatically when the machine is switched on.
The point on the display flashes until the level is reached.
The
STATUS BAR (6)
lights up from the top downwards to indicate that the dishwasher is heating
up.
When the working temperature is reached, the
STATUS BAR (6)
stays on, lit in green.
The optimal wash conditions have been reached.
4.3
Filling the rack
Referring to
Fig. 3
,
to ensure the correct operation of the dishwasher follow the rules described below:
Use a suitable rack, fill without overloading and without overlapping the dishes.
Always wipe the dishes before placing in the dishwasher; do not put dishes with dry or solid
residues in the washer.
Place the empty dishes in the rack facing downwards.
Place plates and the like in the sloping rack, with the inner surface facing upwards.
Place the cutlery in the cutlery basket, handle end down.
Do not place silver and stainless steel cutlery in the same cutlery basket as this will turn the silver
brown and may corrode the steel.
Wash the dishes immediately after use, in order to prevent any residue from hardening and sticking
on them.
Use only solid, dishwasher-proof dishes.
4.4
Cycle selection and start-up
Press the
PROGRAMME SELECTION (3)
or
SPECIAL PROGRAMME SELECTION (2)
button
repeatedly to select a wash cycle that is suitable for the dishes to be washed; the display will show
the cycle number selected
(Fig. 4)
.
To run the programme, press
START (4)
; the
STATUS BAR (6)
starts to flash orange, increasing
from the bottom upwards to indicate the progression of the cycle.
When the cycle is finished, the bar lights up in green
(Fig. 5)
.
For rapid drying, remove the rack from the machine as soon as the cycle finishes.
To stop a wash cycle early, press
START (4)
.
N.B. In hood versions, after the first work cycle the automatic start is automatically enabled; the
subsequent cycles will be enabled automatically when the hood is closed. This operating mode
is marked on the display by “
AS
”.
