INSTRUCTION MANUAL FOR DISHWASHERS
Page 8 of 14
UK
4.7
Automatic cycle start-up
This function is used to make the chosen cycle start automatically when the door is closed. To enable,
proceed as follows (
Fig.6
):
If not made available by default, the function must first be enabled via the settings menu.
With the appliance on and the door open, press and hold (for at least five seconds)
START
(4)
until
AS
appears on the display
.
To disable the function, with the door open press
START
(4)
again for five seconds.
4.8
Removing the integral filter
Move the washing and rinsing arms at right angles to the edge of the door (
Fig.7
).
Lift each semi-filter by the relative handle.
4.9
Emptying the dishwasher
4.9.1 Appliances with no drain pump
Switch the dishwasher off.
Remove the integral filter (
Fig.7A
).
Pull up and remove the overflow pipe
(
Fig.8B
).
Wait for the tub to empty completely.
If necessary, extract the tub filter and clean (
Fig.8C
).
4.9.2 Appliances with drain cycle (*optional)
If present, remove the integral filter (
Fig.7
).
If present, remove the overflow by pulling upwards (
Fig. 9
).
Close the door.
Select the cycle
dr
Press
START (4)
to start the cycle.
The machine runs a drain cycle with self-cleaning (*where foreseen) and then switches off.
If necessary, extract the tub filter and clean (
Fig.8C
).
4.10
Turning the dishwasher off
Press
ON/OFF (1)
, on the
DISPLAY (5)
the central segments will light up, indicating that the machine is
powered.
4.11
Resin regeneration (*optional)
When
rEG
flashes on the display in appliances with internal softener, you need to run a regeneration cycle
to restore proper function of the internal softener. Proceed as follows (
Fig. 11
):
Empty and clean the dishwasher.
Remove the integral filter and open the salt container in the tub.
Pour in 250-300 g of regeneration salt (1 or 2 mm grain size kitchen salt with no additives).
Close the container firmly.
Make sure the overflow has been removed.
Close the door and switch the dishwasher on.
Press the
PROGRAMME SELECTION button
(3)
for the resin regeneration cycle;
rEG
will appear on
the display.
Press the
START button (4)
to start a cycle.
The regeneration cycle lasts around 20 minutes.
The dishwasher will switch off when the cycle has completed.
N.B. Do not switch off the machine if a regeneration cycle is underway
