SHOP BULLETIN
#9
If the ~ear box is missing gears either shifting up or
shifting down, this means that the shift linkage is not in
its center location.
To position the shift linka~e into its proper location,
remove the
clutch cover
and push the shift linkage pull rod
No. 1750 forward to its maxlum travel. Mark this position of
the pin in the rod onto the
case
gasket
surface;
use a pen-
cil.
Now pull the rod all the way to the rear and mark this
position of the pull rod pin onto the
case
gasket surface.
Now divide the distance between these two marks. Mark
this center position line over the gasket surface and con-
tinue the line 1/2 inch out over the outside of the case.
Next mark tne center line of the shift shaft pin hole
(No. 1049). Draw this line over the gasket surface and con-
tinue this line onto the outer surface of the
case.
Now
place the cover onto the
case.
If the two lines are not matched, then remove the shift
spindle from the
case
and bend the dog leg portion until the
lines match. Replace the spindle into the
cover
and remark
the
center
line of the shift spindle pin hole. Reinstall the
cover onto the case and re-examine the marks. Adjust the shift
spindle once again
if
necessary.
Maico 72-74.5 Radial Manaual
www.maicowerk.com
Courtesy of [email protected]
