Maico ERO SCAN, Operating Instructions Manual, Page: 23 / 75

Operating Instruction
ERO•SCAN
®
Screening and Diagnostic Version
operating_instructions_8106556-6_EROSCAN_e_15a
16
8106556-5 02/15
The Micro-USB port on the bottom of the instrument is used for
charging via the power supply. Connect the charger as shown
in Figure 2.
Misalignment of the plug and socket can cause damage. The
plug and socket should be visually inspected prior to each
installation of the remote probe. If damage is observed, contact
MAICO Diagnostics.
The indicator labeled ‘CHARGE’ (Figure 3) provides a visual
indication (BLUE) of the battery recharging function and battery
status during operation.
During battery charging the indicator will be lit whenever the
Micro-USB connector is engaged and powered. The rate of
illumination of the indicator provides a means of identifying the
status of the charging function, and is defined as follows:

Steady-state illumination indicates that the battery is fully
charged. This identifies that the charging cycle has been
completed or was not implemented because the battery was
already fully charged.

Slow blink illumination indicates that the charging function
is in process.

Fast blink illumination indicates a fault condition in which
the user would be directed by the Operating Instructions to
return the instrument for service.
During instrument operation, the user is warned of a low
battery condition by the following illumination of the CHARGE
indicator:

Two fast blinks followed by a pause and then repeated until
the battery is charged.
9.3 Installing the Micro-Probe
Turn off the ERO•SCAN
®
and insert the Micro-Probe connector
into the socket on the top of the ERO•SCAN
®
(Figure 4). The
plug will fit in only one direction. A MAICO logo is on the probe
connector and will align with the instrument control panel.
CAUTION
Figure 4
Figure 3
Figure 2