Mahindra THAR CRDe 2015, Owner'S Manual

Page: 89 / 103

13-12
© Copyright Mahindra & Mahindra Ltd.042015
To prevent damage to the windshield, don’t let the wiper arm slap down on
to it.
3. Hold the end of the rubber and pull until the tabs are free of the metal support
4. Carefully insert the new blade rubber. Then install the blade assembly in the
reverse order of removal
13.5.12 Fuel Filter Bleeding/Priming
U52N12
When the fuel level in the fuel tank falls very low, air may enter the fuel lines which
leads to the engine not starting or abrupt switching OFF.
The air has to be removed from the fuel pump by bleeding and priming the fuel
pump. The fuel pump is located next to the battery in the engine bay. Unscrew the
drain nut below the pump by 1–2 turns and observe fuel flow. If there is no fuel flow
or intermittent flow, close the drain nut and pump the fuel filter (top face) repeatedly
using your palm. Again check for fuel flow by unscrewing the drain nut. Once the flow
is normal, tighten the drain nut and try starting the engine. If it fails, drain/pump few
more times and retry. If the engine still does not start, contact your nearest
Authorized Mahindra Dealer for assistance.
13.6 Headlamp Bulb Replacement
The head lamp bulb can be replaced without removing the head lamp assembly
from the vehicle.
To replace the head lamp bulb;
• Ensure ignition is switched OFF
• Remove rear dust cover from the head lamp
• Remove the bulb assembly with connector from the head lamp by unlocking the
wire clamp
MAINTENANCE