2-18
© Copyright Mahindra and Mahindra Ltd. 012020
will need more ground clearance when putting the inflated spare
tyre than when removing the flat tyre.
Make sure to locate the jack properly in the jacking point.
Raising the vehicle with an improperly positioned jack will
damage the jack and may allow the vehicle to fall off the jack
and cause personal injury.
•
Use the jack only for lifting the vehicle during wheel changing
•
Do not raise the jack with any person inside the vehicle
•
When raising the vehicle, do not place any objects on top of
or underneath the jack
•
Raise the vehicle only high enough to remove and change
the wheel
•
Follow jacking instructions
•
Do not start or run the engine while your vehicle is
supported by the jack
Never get under the vehicle when the vehicle is supported by
the jack alone.
Remove the wheel nuts. Remove the flat tyre straight off and then
place it aside. Roll the spare wheel into position and align the holes
of the disc with the bolts. Lift the wheel and hand tighten the top
wheel nut. Wiggle the wheel and press it back over the other bolts.
Re-instal the wheel nuts with the tapered end inward and tighten by
hand. Press the wheel inward and tighten the wheel nuts further.
Before lowering the wheel, hand tighten the nuts in diagonal
sequence so that wheel is flush against the hub/drum.
Never use oil or grease on the bolts or nuts. Doing so may lead
to over tightening of the nuts, wheel nut spanner slip, damage
the bolts and also may cause personal injuries. Also, nuts may
loosen and the wheels may fall off, which could cause a serious
accident. If there is oil or grease on any bolt or nut, clean before
installing wheel nuts.
U82B18
Tapered End
G
GE
EN
NE
ER
RA
AL
L