6
ASSEMBLY
ASSEMBLY INSTRUCTIONS
IMPORTANT: UNLESS OTHERWISE SPECIFIED TORQUE ALL BOLTS ACCORDING TO TORQUE SPECI-
FICATION TABLE (SEE TABLE OF CONTENTS) WHEN STATED: TIGHTEN FIRMLY. REFER TO PARTS
BREAKDOWN SECTION FOR PART IDENTIFICATION.
TOOLS REQUIRED
Wrench: 7/16’’,18mm
Socket: 7/16’’, 18mm
Ratchet:
NOTE:
In this manual, the right and left side is determined by sitting on the seat of the vehicle facing toward.
Overall view
Note:
This snowblower was designed to be used on a 35 to 65 HP category 1 or 2 tractor and on the category 1
or 2 quick hitch. The maximum speed of the tractor’s PTO must be 540 RPM.
WARNING
THIS ACCESSORY IS HEAVY!
To avoid risk of strain injury, NEVER lift the
accessory by hand alone when handling the
components or assembly. Use proper lifting device
and seek assistance.
When accessory is off the ground, NEVER be
underneath the accessory. Serious injury including
possibility of death could occur if accessory were to
drop suddenly.
Always wear protective shoes and appropriate gloves
when manipulating or using this equipment.
WARNING
Operate only tractors equipped with a Roll
-
Over
Protective Structure (ROPS) and seat belt.
Counterweights may be required to maintain steering
control.
Refer to tractor’s owner’s manual to determine the
appropriate counter weights are required.
Reduce the speed when transporting the snowblower
to reduce the bouncing and momentarily losing
control of the steering.
