4
ASSEMBLY
When rear chain guard is installed, tailwheel must be
moved back by one set of holes.
Make sure to position the wheel support correctly.
Select hole corresponding to your implement.
Refer to (
4’, 5’ or 6’
) on picture.
Install tail wheel assembly as shown with following
items:
Tail wheel installation
Adjustment levers installation
REF. ENGLISH DESCRIPTION
QTY.
1
Wheel support asembly
1
2
Hex. bolt 1/2" n.c. x 3 1/2" GR5
1
3
Nylon Insert lock Nut 1/2" n.c.
1
Select hole corresponding to desired height:
“
A
” for the lowest cutting height.
“
G
” for the highest cutting height
Select hole “
X
” or “
Y
” to have adjustment lever as
vertical as possible.
Install adjustment levers as shown with following
items:
REF. ENGLISH DESCRIPTION
QTY.
1
Adjustment lever
2
2
Sleeve
1
3
Hex. bolt 1/2" n.c. x 4 1/4" GR5
1
4
Hex. bolt 1/2" n.c. x 3 1/2" GR5
1
5
Nylon Insert lock Nut 1/2" n.c.
2
Tighten all bolts to correct torque.
Tighten to correct torque.
Tailwheel Height Adjustment
From owner’s manual of rotary cutter:
refer to “
Adjustment”
section for proper setting.
See «
Deck Leveling & Height Adjustments
»
ADJUSTMENT
X Y