BA322301-en
35
4.6.5
Cable Remote Control
WARNING
Connection only permitted by qualified electrician. The operator is responsible
for ensuring that nobody is within the danger area.
A cable remote control is optionally available for the lift. With this it is possible
to operate the lift away from the control box. This gives the operator the
opportunity to gain improved visibility into the hazardous area.
The cable remote control is generally equipped with the large control element
and additionally with an emergency stop button.
Handover of the control
Control box to cable remote control:
Press the F1 and F2 buttons on the control box
simultaneously.
Subsequently, control is only possible via the cable remote
control.
Cable remote control to control box:
Press the F1 and F2 buttons on the cable remote control
simultaneously.
Subsequently, control is only possible via the control box.
When not in use, properly wind up the cable of the cable remote control and
store it safely.
4.7
Troubleshooting
5
Troubleshooting
5.1
Safety Information
WARNUNG
•
The relevant health and safety regulations must be observed.
•
Wear personal protective equipment.
•
Service work may only be carried out by authorised service technicians.
•
Repairs, maintenance and set-up work should only be carried out when the
machinery is stationary. The unit must be disconnected from the power
supply and secured against being switched on again.
•
Work on the electrical part of the lift may only be carried out by qualified
staff or specialist electricians.
ATTENTION:
The 230V sockets on the control element(s) also carry current
Summary of Contents for ZS SQUARE II 3.5
Page 16: ...16 BA322301 en 2 4 3 Set up Diagrams...
Page 32: ...32 BA322301 en B B 3 4 B C 5...
Page 52: ...20 PL670000_002 de...
