24
BA491701-en
Pos: 119 /Technische Dokumentation/Alle Geräte/Überschriften/Überschriften 1.1/E/Überschrift 1.1: Einstellungen am hydraulischen Fahrwagen @ 24\mod_1302611581158_75.docx @ 994317 @ 2 @ 1
5.5
Setting the Hydraulic Jack
Pos: 120 /Technische Dokumentation/Hebetechnik/49 Radgreifer-Hebebühnen/0001 Radgreifer-Hebebühnen Alle/Inhalte/Inhalt: Einst. am hydr. Fahrwagen (Bilder) RG-HBZ @ 24\mod_1302257252608_0.docx @ 993783 @ @ 1
Pos: 121 /Technische Dokumentation/Hebetechnik/49 Radgreifer-Hebebühnen/0001 Radgreifer-Hebebühnen Alle/Inhalte/Inhalt: Einst. am hydr. Fahrwagen (Text) RG-HBZ @ 24\mod_1302259063767_75.docx @ 993823 @ @ 1
Note that the jack must be mounted to the column when making any settings.
A: Setting the Lowering Speed
The lowering valve is located on the right-hand side of the cylinder. To set the lowering speed,
adjust the threaded pin using an Allen key while holding the lock nut firmly with an open-end
wrench. Check for correct setting by carefully lowering the jack.
Threaded Pin
OPEN
INCREASE
Lowering Speed
CLOSE
REDUCE
B: Setting the Responsiveness of the Automatic Lowering Function
The automatic lowering valve is located on the left-hand side of the cylinder. Remove the screw
plug using an Allen key, then insert a flat-tip screwdriver to set the adjusting screw. Soak up
leaking fluid with a rag. Reinstall the screw plug.
Adjusting Screw
OPEN
REDUCE
Responsiveness
CLOSE
INCREASE
Pos: 122 /-----Format-----/MANUELLER UMBRUCH Seitenumbruch @ 0\mod_1134403577687_0.docx @ 1277 @ @ 1
A
B
