MAGUIRE Weigh Scale Blender, Installation Operation & Maintenance

Page: 44 / 141

M A G U I R E P R O D U C T S , I N C .
44
W E I G H S C A L E B L E N D E R

Controller Keypad
– Summary Description
Detailed explanations are given on the pages that follow.
AUTOMATIC OPERATION MODE : (normal operation on power up)
VIEW View Data: date, time, cycles, and each component weight.
Press VIEW, to print data.
RECP Enter and retrieve stored RECIPES.
BTCH View BATCH data: Target Weight, Current Portion, and
Accumulated Total, and Batch Count. CE = clear displayed field.
FAST Run rapid FAST cycles after a normal weighed cycle.
TAG Tag Work Order and Operator numbers to all reports.
EXIT Press to EXIT all sequences from ALL MODES.
SET Press to review or change settings.
CE Press to display "raw signal" weight readout for 3 seconds.
MANUAL OR PROGRAM MODE
: Press: ; then (11111) or your own 5 digit password.
OPER Operate all devices manually; open and close valves.
TIME Operate devices for a selected time period.
CAL Operate devices to learn rate.
Above keys use 1 through 9, A, B, C, DUMP, MIX, HOLD, ALARM.
ZERO Zero the tare weight with the bin empty.
FULL Using known weights, enter gram weight to calibrate load cells.
00 Clear DATA fields.
99 Set flag to enable weight calibration of load cells.
PROGRAM MODE ONLY : Press: ; then (22222) or your own password.
SET Enter settings if access in Automatic mode has been locked out.
PARA View or change system parameters.
Press PARA for next in list, "*" for previous, SET for next table, VIEW for previous table.
STAR FUNCTIONS: Press and two numbers for the following functions:
02 Extrusion and Yield Control. 69 Regrind as second natural.
03 Four digit (xx.xx) settings. 71 Color percent of blend.
04 Simulate FOUR software. 72 Additive percent of blend.
05 Inhibit table clearing. 74 Stop, alarm MAX wt exceeded.
11 DATE - TIME, real-time clock. 75 Alarm on weight drop.
12 Move table from ROM to RAM. 77 Print parameters.
18 Language Selection 78 Change program mode PASSWORD.
22 LIW Model Selection 82 Precision Ratioing.
23 Move from RAM to EEPROM. 83 Progressive Metering
25 ROM OK flag, "CE" to clear. 86 Backdoor Password
32 Move from EEPROM to RAM. 87 VOLUMETRIC operation.
44 End cycle - bin full. 88 Print display readout.
45 Change MANUAL mode password. 89 Select pounds, kilos.
47 Totalizer flag. 93 Update WSB software from USB drive
48 Dispense range xx.x to xxx. 95 Select COM port Baud Rate
52 Double dump weigh bin. 97 USBC Driver version display, update, verify
54 Print cycle information. 98 Display raw weight number.
57 Alternate Liquid Color 99 Enables Weight Calibration of the Load Cells
66 WSB I.D. number (1-255). 00 Clear All Data Fields.
67 Modbus Enable / Disable