MAGUIRE LPD-30, Installation Operation & Maintenance

Page: 18 / 127

Maguire Products, Inc.
Edition: November 5, 2010
18
LPD Dryer
®
At the lower, right side of the Dryer are two ports. The “Dry Resin
Takeoff” port and the “Convey Vacuum Connection” port. Using a hose
clamp, attach one end of the 2-inch vacuum line to the “Convey Vacuum
Connection” port.
Attach the other end of the 2-inch vacuum line to the port located on top
of the Maguire Receiver (vacuum), again using a hose clamp. Orient the
top port to face the right side of the Dryer by loosening the two clamps
and rotating it to face the right side if the Dryer for better access to the
“Convey Vacuum Connection” port.
Next, attach the material convey line to the
Maguire Receiver’s lower port (material
convey) using a hose clamp. The other end
of the material convey line will attach to
your material source such as a Material
Pick-Up Lances as pictured to the right.
Attach one end of the Convey Sensor Cable to the cable
port located at the base of the Maguire Receiver.
Attach the other end of the Convey Sensor Cable to the
Convey Sensor port located on the left side of the Dryer’s
controller.
DO NOT wire tie the SENSOR cable to the MATERIAL hose. This will induce
static spikes into the processor. Keep them separated.