Maguire Products SW SERIES, Instruction And Operation Manual

Page: 9 / 15

M A G U I R E P R O D U C T S , I N C .
9
S W S E R I E S S W E E P E R
SECOND STEP - BOLT THE VERTICAL ASSEMBLY TO STAND
1. Refer to enclosed drawing for
identification and location of parts
& hardware. Please note that the
front or sloped side of the sweeper
assembly should face the leg that
has the chain catch plate. Ensure
to center the vertical assembly on
the frame of the stand.
THIRD STEP – ATTACH THE PICK-UP TUBE ASSEMBLY
2. First, remove the aluminum end guard by
removing the two self-tapping screws (see
photo). Allow the clear Lexan® chain guard
to hang down. It is not necessary to remove
the Lexan® chain guard.
3. Remove the four (4) locknuts and washers
that are attached to the sprocket hub
assembly.
4. Raise the motor control assembly to allow for
clearance to insert the pick up tube assembly
into the pulley hub assembly. Slowly, push
upward until the flange is seated firmly
against the sprocket hub assembly.
5. Reinstall and tighten the four ¼-20 locknuts
and washers. Please refer to enclosed
assembly instructions for details.
(2) Remove end guard (4) Insert pickup tube
(5) Reinstall washers, locknuts (6) Reinstall end guard
6. Reinstall the aluminum end guard and tighten screws. Note: Be sure there is clearance
between Gaylord frame top member.
Drive Chain Adjustment
If the chain needs adjustment, remove the clear Lexan® portion of the chain guard.
Loosen the (4) four machine screws. Apply pressure to the rear of the motor (This will
apply tension to the chain and sprocket). Do not apply too much force to the chain tension.
Then tighten the (4) screws at the bottom of the motor / bracket assembly. Re-install the
clear Lexan® belt guard.