Maguire Products MLS Clear Vu, Installation Operation & Maintenance

Page: 8 / 38

Maguire Products, Inc.
8
MLS Clear Vu

2
– Operation
Installation
YOUR SYSTEM consists of:
▪
One FILTER/POWER STATION , with central filter; dust collection container; vacuum
blower/motor; 1, 2.5, 5 or 10 HP, all on wheels for portability.
▪
One EIGHT STATION CONTROLLER , to be placed on top of the power station, with
outputs to each receiver and the power unit, alarms, and an on/off switch and status
light for each station.
▪
Up to eight RECEIVERS , filterless, 10 pound capacity, clear, with level sensor and
vacuum sequencing valve built in.
If your application is "beside the press" using a "pick-up" lance, the following kit is provided for
each receiver.
1 Lance with two 2" hose clamps in box.
12' flexible material hose, 1.5" ID
Each CUSTOMER must supply, or purchase separately:
Vacuum and material line using 1.5", 2", or 2.5" tubing, (steel, aluminum, or PVC), and tees
and elbows as required.
1. RECEIVERS:
Mount receivers over the hopper compartments you wish to load.
Receivers are sized to fit over round openings as large as 10 inches in diameter.
Larger openings require adaptor plates. Openings smaller then 8" diameter must be
enlarged using the drawings provided on the next page.
The 8" x 8" square bolt pattern allows you to select 4 orientations for the receiver.
Select an orientation so the VACUUM line is located best for your installation. The
material inlet line swivels 180 degrees
2. LEVEL SENSOR:
The LEVEL SENSOR is mounted into the base of the receiver. It is placed directly
under the flow of material. If you select another location, be sure that it is not
uncovered before material is completely empty from the receiver.
The sensor LED is ON when COVERED, OFF when UNCOVERED. See
ADJUSTMENTS, page 18, if you suspect it needs adjustment.