2 - Introduction
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 25 of 356 (
D99875607-91
)
2.9.1
How to Use the MCP Commands Page
The move the various parts of the ExpressCard individually, rather than as part of a standard sequence,
use the touchscreen to navigate to
Menu
>
Settings
>
Service
>
MCP Commands
to open the
MCP
Commands
page.
Note that the
MCP Commands
page may allow you to make moves that could
damage the device -- think carefully before sending a direct move command!
Table 2.1
MCP Commands
sequence that exercises the device’s complete range of
movement, in addition to moving a card from hopper 1 to the output bin. You can test by pressing each
button in the list and verifying the described action happens correctly. The gray highlighted rows are a
shorter sequence that also moves a card from hopper 1 to the card output bin.
Table 2.1 - Controller Buttons and Corresponding Movements
Press This Button
Verify This Happens
Pusher Home
Hopper shuttle’s pusher moves into safe position for move
8
To Hopper
Hopper shuttle moves to (or stays at) manual feed slot, slot light flashes
7
To Hopper
Hopper shuttle moves to (or stays at) hopper 1, slot light stops flashing
6
To Hopper
Hopper shuttle moves to (or stays at) hopper 1
5
To Hopper
Hopper shuttle moves to (or stays at) hopper 1
To Manual Feed
Hopper shuttle moves to (or stays at) manual feed slot, slot light flashes
4
To Hopper
Hopper shuttle moves to (or stays at) hopper 1
3
To Hopper
Hopper shuttle moves to (or stays at) hopper 1
Shuttle Home
Hopper shuttle moves near hopper 1
2
To Hopper
Hopper shuttle moves to (or stays at) hopper 1
1
To Hopper
Hopper shuttle moves to (or stays at) hopper 1
Bot Cartridge Unload
,
Indenter Move
Rear (black) indent cartridge moves out of embosser toward rear of device
Bot Cartridge Load
,
Indenter Move
Rear (black) indent cartridge moves back into embosser
Bot Cartridge Home
,
Indenter Move
Rear (black) indent cartridge moves back into (or stays in) embosser
Bot Cart to Indent Loc.
,
Indenter Move
Rear (black) indent cartridge moves between letters on embosser wheel
Bot Ribbon Advance
,
Indenter Move
Ribbon in rear (black) indent cartridge advances by about ¼”
Top Cartridge Unload
,
Indenter Move
Only if testing ExpressCard with Front Indenter installed:
Front (white) indent cartridge moves out of embosser toward rear of device
Top Cartridge Load
,
Indenter Move
Only if testing ExpressCard with Front Indenter installed:
Front (white) indent cartridge moves back into embosser
