Magtek ExpressCard 2000, Hardware Service Manual, Page: 161 / 356

5 - Removal and Re-installation
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 161 of 356 ( D99875607-91 )
Figure 5-53 - Re-connect USB Cable to J31 (TOP VIEW FROM REAR)
6) Secure the power cable to its connector using a bead of silicone adhesive as shown in Figure 5-54 .
Figure 5-54 - Silicone Adhesive On Image Printer Power Connector (FRONT RIGHT VIEW)
7) Re-attach the top access door by reversing the steps you used to lean it back.
8) Install the original printer ribbon, or obtain and install a new image printer ribbon from the customer.
9) Re-connect the power and network cables to the device and power it on.
10) Configure the image printer ribbon following the steps provided in D99875600 ExpressCard 2000
Installation and Operation Manual .
11) Calibrate the image printer by following the steps in section 6.3 How to Calibrate the Image
Printer Module .
12) Perform any relevant adjustments from section 6 Adjustments as needed.
13) Close and secure the top access door.
14) On the touchscreen, navigate to
Menu
>
Samples
, create a sample card, and make sure the device
functions properly and the sample looks correct.