Page 2 of 4
Page 3 of 4
Device Address Setup
•
Using My Computer go to the folder
C:\program files\Magtek\Excella-STX
.
•
Run the
ExcellaUSBConfig.exe
program (see Figure 2 below)
Figure 2. Excella Setup Utility Screen
•
For
Subnet Mask,
Network Device ID
and
Excella Device
,
accept the defaults shown.
•
Click once on the
Search
button (this will automatically fill in valid IP addresses).
•
Click on the
Apply
button.
•
Click
OK
.
•
Close this program.
•
Continue to Step 4, INSTALL INK CARTRIDGE(S) below.
3. ETHERNET INSTALLATION
Connect cables
•
Connect Ethernet interface cable, USB to Excella STX (refer to Figure 1 above).
•
Connect round connector from the power supply to Excella.
•
Connect the power cord to the socket on the power supply block.
•
Connect the three-prong power cord
to AC wall outlet.
•
Wait until only the middle LED is illuminated with a steady green.
•
Connect interface cable
to PC.
Ethernet Configuration
•
In your web browser, type Excella STX’s default Ethernet IP address as follows:
http://192.168.10.100
;
Excella STX’s built-in web page will be displayed.
•
In the
User Menu
, click on
Configuration
.
•
Select the
Ethernet
tab and configure all parameters shown (see Figure 3 below).
•
Click on
Save Settings
and close the web browser.
•
Continue to Step 4, INSTALL INK CARTRIDGE(S) below.
Figure 3. Ethernet Configuration Screen
4. INSTALL INK CARTRIDGE(S)
•
Remove the outer cover by pressing the release buttons on each side and lifting the cover.
•
Remove the center cover by pressing the rear/front release buttons and lifting the cover.
•
Ensure the printer latch is down and locate the alignment pegs on the Printer/Cartridge
and the guide
holes in the Printer Base (see Figure 4 below).
•
Slide the alignment pegs into the guide holes as indicated in the figure below.
•
Raise the latch so that it touches the Printer/Cartridge.
•
Press the latch into the lock position, and move the Cartridge slightly to ensure it is locked.
•
If needed, perform steps 1-4 on the Front Printer/Cartridge located inside of the exit path.
Figure 4. Rear Print Cartridge Installation/Removal
