4 - Installation
DynaFlex and DynaFlex Pro| Three-way Secure Card Reader Authenticators | Installation and Operation Manual
Page 20 of 56 (
D998200382-10
)
4.3
Connecting to a Host
4.3.1
About Connecting to a Host
The following sections provide steps for connecting DynaFlex to a host via the various available physical
connection types.
4.3.2
How to Connect DynaFlex to a Host or Charger via USB
Figure 4-1 - Connecting DynaFlex to a USB Host or USB Charger
To connect DynaFlex or DynaFlex Pro to a USB host or charger using the USB-C port, follow these steps
(for reference see
and section
):
1)
For best results, use the cable that is included with the device or another cable from
on page
. These cables are designed specifically for DynaFlex products and
include ferrite shielding at both ends of the cable to reduce emissions and interference.
2)
Connect the USB-C end of the cable to DynaFlex or DynaFlex Pro.
3)
If you plan to route the cable out the back of the device, route the cable through the cable
management clip to change its direction. Even if you are not routing out the back, you may use the