6 - Operation
DynaPro Go| Handheld PIN Pad Device with MSR/Contact/Contactless | Installation and Operation Manual
Page 47 of 60 (
D998200129-10
)
6.5
Card Reading
6.5.1
How to Swipe Magnetic Stripe Cards
To swipe magnetic stripe cards, cardholders should:
1)
Wait for the device to display an action prompt (see
2)
Locate the magnetic stripe reader on the top of the device, shown in
3)
Orient the card with the magnetic stripe facing away from the padlock logo on the magnetic stripe
reader.
4)
Swipe the card through the magnetic stripe reader.
If the device can not read the card’s magnetic stripe data, it will prompt the cardholder to swipe the card
again. If the device notifies the host that it is unable to read payment information for the transaction, the
host software may choose to revert to prompting the operator to enter card data manually (see section
6.5.4 How to Enter Card Information Manually)
.
Immediately after the user swipes a magnetic stripe card, the device disables the option to use the
contactless interface. If the cardholder needs to revert to a contactless card or device for payment while a
transaction is in process, the operator should cancel the transaction and start again.
Figure 6-13 - Example Card Swipe Screens
Figure 6-14 - Swiping a Magnetic Stripe Card
