5 - Operation
DynaPro| Secure Cryptographic Device for PIN and Data Entry | Installation and Operation Manual
Page 30 of 40 (
D99875586-41
)
5.3
Card Reading
5.3.1
How to Swipe Magnetic Stripe Cards
When the appropriate prompt appears (see
for an example), swipe the card with the magnetic
stripe down and facing toward DynaPro’s keypad as shown in
. If the magnetic stripe data can
not be read, the host software may prompt the cardholder to swipe the card again.
Figure 5-2 - Example of Swipe Card Page
5.3.2
How to Insert Contact Chip Cards
An EMV transaction is started by the host sending an amount to be approved by a cardholder, as shown in
section
Verify the Transaction Amount.
After the cardholder accepts the amount, the device prompts the cardholder to insert a chip card by
showing:
Figure 5-3 - Example of EMV Chip Card Insertion
When the appropriate prompt appears (see
for an example), insert the card with the contacts
facing up and the magnetic stripe facing down, as shown in
The display shows
