![background image](http://html1.mh-extra.com/html/magtek/dynamax/dynamax_quick-installation-manual_3648775001.webp)
Connection and Mounting
Mounting Options: Desktop anti-skid pad, attached weight, threaded
mounting holes and optional recessed cable, and adhesive and optional
recessed cable, and Hook-and-Loop fasteners, and Lanyard.
USB HID:
Make sure the host and device are powered off. Connect the
small end of the USB cable to DynaMAX. The Micro USB connector can be
swiveled to orient vertically for connections through the mounting surface,
or horizontally for other types of cable run. Connect the large end of the USB
cable to the host computer’s USB port. Power on the host computer. Power
on the device using the power switch. On the host, install and configure the
software to be used with DynaMAX (USB HID).
Wireless:
Mobile wireless mode requires batteries: To use a wireless
connection, the device must be powered by two alkaline “AA” batteries.
Install batteries and switch ON power. If the device is waiting to pair, it
should flash the wireless status LED for up to 60 seconds. Otherwise you
may test the batteries by swiping a card and making sure the LEDs flash.
On the mobile device, go to Settings and enable wireless connection. Scan
for devices, and select the DynaMAX you want to pair to. Note: you will see
the DynaMAX and its serial number. When prompted, enter factory default
passcode 000000 (or the device’s actual password if it has been configured
differently). On the mobile device, install and configure the software you
intend to use with DynaMAX.
Overview
DynaMAX, a secure card reader authenticator, gives users the flexibility
needed in point of sale and point of service environments. Whether used
by a bank, hotel, retail merchant, food truck, or theatre, DynaMAX works
with USB wired or a wireless connection delivers one reader for mobile or
stationary needs, saving the user money on a single, low-cost, yet highly
secure device.
Major Components
Power
Slide the power switch to the right to turn ON. Slide left to turn OFF.
Mobile powered by two (2) Alkaline “AA” batteries. Users have the freedom
to operate DynaMAX as a wireless device while taking payments on the go.
Battery standby time is 5 years; 3 VDC on battery power; Max current draw
is < 100mA.
To install batteries: Use your finger to squeeze the release tab on the battery
cover, and remove the battery cover. Remove used batteries if they are
already installed, and dispose of them according to local e-waste guidelines.
Insert the new batteries, making sure to orient each battery to the plus and
minus signs stamped inside the battery compartment. Re-attach the battery
cover and snap it closed.
Counter top powered by USB via Micro-USB B jack. Use the USB interface
and power to operate while connected to a PC or tablet-based POS system
where a USB host and power are available. Voltage is 5 VDC; Max current
draw is < 100mA.
Compatibility and Operating System
iOS 7.1; Android 4.4.2; USB: Windows 7, Windows 8; Wireless: Windows 8.1
on hosts with wireless hardware
DynaMAX
Secure Card Reader Authenticator
Quick Installation Guide
Setup and Installation
MagTek
®
Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 562-415-6800 | f 562-546-6301 | www.magtek.com
MICRO USB B PLUG
CON 1
CON 2
micro-USB connection
USB connection
MSR swipe path
Lanyard mount point
Power on/off switch
General status LED
USB connection
Battery compartment (underneath)
Bluetooth status LED