2 - How to Set Up the MagTek SCRA Libraries
Dynamag, DynaMAX, and eDynamo| Secure Card Reader Authenticator | Programmer’s Reference (WCF)
Page 12
1)
If you are using an external Bluetooth adapter, install any required drivers and connect it to the host.
2)
On the host, install and configure the software you intend to use with DynaMAX or eDynamo:
a)
Make sure the host software is configured to look for the device on the proper connection.
b)
Make sure the host software knows which device(s) it should interface with.
c)
Make sure the host software is configured to properly interpret incoming data from the device.
This depends on whether the device is configured to transmit data in GATT format or streaming
format emulating a keyboard.
3)
Make sure the DynaMAX’s batteries are installed and have adequate charge. If using eDynamo,
make sure the device has an adequate charge.
4)
Test the batteries by powering on the DynaMAX or eDynamo device. Provided the device is not
already paired, the Bluetooth Status LED will flash blue every two seconds for up to 60 seconds until
pairing is complete. If the Bluetooth Status LED is solid blue, the device is already paired with a
host. Unpair from the host it is already paired with before continuing.
5)
Enter app mode, scroll down to
Apps by name
, and launch the Windows
PC Settings
app.
6)
In the left side navigator, select
PC and devices
>
Bluetooth
.
7)
Make sure Bluetooth is turned on and close the
PC and devices
app.
8)
Launch the Windows
Manage Bluetooth Devices
app by following these steps:
a)
Enter desktop mode by swiping in from the left side of the touchscreen.
b)
Touch the Bluetooth icon in the system tray and select
Add a Bluetooth Device
(see
