4 - Installation
DynaFlex II| Product Family | Installation and Operation Manual
Page 20 of 78 (D998200554-10)
4.3
Connecting to a Host
4.3.1
About Connecting to a Host
The following sections provide steps for connecting
DynaFlex II products
to a host via the various
available physical connection types.
4.3.2
How to Connect DynaFlex II Products to a Host or Charger via USB
Figure 4-1 - Connecting to a USB Host or USB Charger. Left: Countertop Models. Right: Kiosk Models
To connect
DynaFlex II products
to a USB host or charger using the USB-C port, follow these steps (for
reference see
and section
1.8 About DynaFlex II Components
):
1)
For best results, use the cable that is included with the device or another cable from
on page
. These cables are designed specifically for DynaFlex II products
and include ferrite shielding at both ends of the cable to reduce emissions and interference. If the
solution design requires an alternate cable, contact MagTek for assistance with ferrite selection and
placement, and with connector overmold design.
2)
Connect the USB-C end of the cable to DynaFlex II or DynaFlex II PED.
3)
If you plan to route the cable out the back of the device, route the cable through the cable
management clip to change its direction. Even if you are not routing out the back, you may use the
