www.magomhrc.com
504099-309
2-WAY VALVE M3 V2
–
VOLVO A60H
Connect 1A-1B to hydraulic cylinder Nr 1.
Connect 2A-2B to hydraulic cylinder Nr 2.
Connect 3A-3B to hydraulic cylinder Nr 3.
Connect 4A-4B to hydraulic cylinder Nr 4.
SCHEMA
SPECS
•
2-way hydraulic valve (to control TWO movements).
•
Pressure: Up to 30 bars.
•
Recommended working pressure: 5-18 bars.
REQUIRED:
•
2 x micro-servo. We recommend HXT 900 (
6003-001
).
•
Hydraulic oil. We recommend MAGOM HRC hydraulic oil (
5050-001
).
MICRO SERVO ASSEMBLY
14 mm
Cut the servo horn as
shown in the picture.
STEP 1
Total length must be 14 mm.
Working angle is
about 60º, same as
servo angle.
At the neutral point, the valve is closed.
Please note that this product is not a toy and not suitable for youngters under the age of 16. Technical details may be
subject to changes and modifications. All images and designs are property of MAGOM HRC. For any doubts or
questions, please contact us throught www.magomhrc.com.
STEP 3
1. Mount the horn to the servo without screw.
2. Attach the servo to the valve (If necessary, loosen the valve tabs
before screwing the servo to find the midpoint and then retighten the
valve screws).
3. Servo horn must not press the rotating valve.
1. Connect the servo to the receiver.
2. With the station on and the receiver powered, move the servo to the
neutral position with SUBTRIM / TRIM to position 0.
3. Place the valve rotor in the NEUTRAL POINT (see diagram).
STEP 2
