• Gently push the throttle up to raise the Flying Santa about 1.5 to 2 meter from the ground.
LIFT-OFF PROCEDURE (after pairing procedure is completed):
• Put the Flying Santa on flat ground – an uneven surface will adversely affect it takes off.
• Slowly increase the throttle.
• DO NOT look at the remote control transmitter but focus on the Flying Santa.
• As soon as the Flying Santa leaves ground, reduce the throttle slightly. (in the worst case, the Flying Santa will return to the floor, but this is
better than crashing against the ceiling)
• VERY gently increase the throttle if the Flying Santa goes down.
• VERY gently reduce the throttle if the Flying Santa goes up.
• When turning, give brief, small inputs to the direction stick. (most beginners will commonly overcontrol the Flying Santa)
FLYING THE DRONE
TRIMMING THE CONTROLS
• If your Flying Santa veers right (fig. 2),press the left side
trimmer continually until it stabilises (fig. 3).
• If your Flying Santa veers left (fig. 4), press the right side
trimmer continually until it stabilises (fig. 5).
• If your Flying Santa pitches forward (fig. 6), press the backward
trimmer continually until it stabilises (fig. 7).
• If your Flying Santa pitches backward (fig. 8), press the forward
trimmer continually until it stabilises (fig. 9).
fig. 3
fig. 5
fig. 9
fig. 7
Keep going right
fig. 2
fig. 8
Keep going backward
fig. 6
Keep going forward
Keep going left
fig. 4
5
