Magnum MIG 208 Alu Synergy, Manual

Page: 21 / 24

21
Every month?
ABOUT Check the condition of the electrical connections inside the source. ABOUT Check the condition of the electrical connections inside the source.
ABOUT Oxidized surfaces should be clean and tighten loose parts. ABOUT Oxidized surfaces should be clean and tighten loose parts.
ABOUT Clean the inside of the device by means of compressed air. ABOUT Clean the inside of the device by means of compressed air.
9.
INTERFERENCE WELDERS AT WORK (CODES device errors)
Overheating. Wait until the unit cools.
ALL 001 - too high or too low a supply voltage. Be sure to check the mains power supply. ALL 001 - too high or too low a supply voltage. Be sure to check the mains power supply.
ALL 002 - short circuit between the welding torch and ground. Locate and eliminate short circuit. ALL 002 - short circuit between the welding torch and ground. Locate and eliminate short circuit.
ALL 003 - Overcurrent circuit welding. Be sure to check the speed of the feeder and / or the welding current is not too ALL 003 - Overcurrent circuit welding. Be sure to check the speed of the feeder and / or the welding current is not too ALL 003 - Overcurrent circuit welding. Be sure to check the speed of the feeder and / or the welding current is not too
high.
symptoms
Cause Procedure
No feed of the electrode
wire (feeder motor is
running).
For poorly tightened pressure.
Tighten the clamp properly.
Contaminated guide wire in the holder. Clean the guide wire electrode.
A predetermined groove roll does not correspond to the
diameter of the wire.
Brought into line with the roll diameter of the
wire.
Locked wire electrode at the end of
the current.
Replace contact tip.
No electrode wire feed
(feed motor is not running).
Damaged engine.
Semi-automatic pass to the site.
Faulty control system. Semi-automatic pass to the site.
Irregular wire feed electrode.
Current damaged tip. Replace with a new tip.
Damaged spiral holder. Replaced.
The groove feeding roller is dirty, damaged, or
the diameter of the wire. Replace the brushhead replace the roll or
roller to choose the diameter of the wire
used.
Not to bow strikes
Failure to properly contact the terminal of
the return duct.
Improve contact terminal.
Wypięty plug polarity changes.
Plug the connector in the correct slot.
Arc too long and irregular.
Welding current too high. Reduce welding current.
Wire feed speed too small. Increase the speed of wire feed.
Arc too short.
Welding current too low.
Increase welding current.
The wire feed speed too high. Reduce the wire feed speed.
After the power indicator light is not
illuminated.
No power supply.
Connect the power supply.
Blown fuse in the mains. Replace the fuse with the same efficient.
Faulty switch. Replace the main switch.