- 5 -
SETTING UP YOUR MD 90
1.
Place your tuner the shortest distance possible from your pre-amplifier/
integrated amplifier, being careful to avoid areas that may cause extreme
temperatures.
2.
Connect your tuner to the pre-amplifier, using cables/ inter-connects that are
consistent with the rest of the inter-connects in your system. For a single
ended (un-balanced) system the cables will be connected to the RCA
connectors labeled “unbalanced out” on the rear panel of your tuner to an
unused aux. input on the rear of your pre-amplifier/ integrated amplifier. For
connection to a balanced system, the balanced cables will be connected from
the XLR outputs marked “output balanced” on the rear of your tuner to the
balanced inputs on the rear of your pre-amplifier/ integrated amplifier.
3.
Connect your FM antenna cable to the
ANTENNA IN
terminal on the rear
panel of your tuner. The connection type on the back of your tuner is an “F”
connector (75 ohms). Should your antenna cable be 300 twin lead, you may
convert this to 75 ohms with a 300 ohm to 75 ohm balun/ transformer.
4.
Make sure that the center conductor of the cable is properly inserted into the
connector. If you do not possess an antenna, attach the
temporary
wire
(enclosed in box) to your tuner. Place this into the “F” connector input on the
rear of your tuner.
Please note that the piece of wire provided should only be used as a medium
to test and setup the tuner, to maximize performance with your tuner a better
antenna system is recommended. Magnum Dynalab offers a number of
different antennae, these antennae are discussed in the
Reception Techniques
in the back of the manual. If you have any questions please call your dealer or
contact Magnum Dynalab directly.
5.
Unwrap the EIA AC cord and plug the EIA end into the rear socket marked
“Power Input” on the rear panel of your tuner. Plug the other end of the AC
cord into a 120/220/230/240 volt continuous AC source that you are
using.
Note: Many countries that use 220/230/240 volts have a special FM
transmitter, tuning de-emphasis for these countries may be different. Please
consult Magnum Dynalab for the correct usage. If your tuner is used in a
country where the tuning de-emphasis is set incorrectly the sonic performance
will be seriously affected.
