- 8 -
4.
Power up the MD 208 by switching the main power rocker switch found on the
rear of the MD 208, to the “ON” position.
5.
Press and HOLD the
“Input”
button (found on the faceplate of the MD 208) for at
least 3 seconds. A red LED above the input button will light, and this indicates
that the theater mode of input A4 is now active.
6.
Input A4 is now the dedicated input for you to listen and control volume with your
home theater processor (Meaning that when you listen to regular music you use
the preamplifier found in the MD 208). Once input A4 has been activated into
Home Theater
mode, volume on input A4 will now be controlled via your external
processor preamp.
CAUTION
As standard practice, you should always turn off the main power to the MD 208
(found on the rear panel of the MD 208), whenever any source component,
interconnect or loudspeaker is being changed in your system.
Be aware, when activating
Home Theater
mode on input A4, the volume level on
input # 4 will be wide open. Please make sure that the RED LED above the input
button is not lit if a regular source is connected to input A4.
HOOKING UP A SUBWOOFER TO YOUR SYSTEM
1.
Make sure your receiver is turned “OFF”.
2.
Using RCA cables, connect one end to the
Pre Out
input marked on the rear of
the Receiver, the other end to your subwoofer.
3.
Turn the subwoofer “ON”.
4.
Turn the receiver on and adjust the volume level to suit you.
Please note the volume of the subwoofer is controlled by the volume control on the
receiver.
TAPE OUT LOOP
This is used if you wish to record the music you are listening to. Connect this to a
recordable peripheral source.
