Magnum MD 109, Instruction Manual

Page: 7 / 19

INSTALLING THE MD 109
1.
Position the tuner the shortest distance from your preamplifier. Avoid putting
the unit where there are extremes in temperature.
2.
Make sure that the MD 109, with specially designed feet using Vibrapod
isolators, is safely positioned on a shelf designed to hold at least 60 pounds
(26.55 Kg)
3.
Remove the AC cord from the pouch on the lid of the carrying case and plug it
into the AC receptacle at the rear of the unit
. DO NOT PLUG THE CORD INTO
THE WALL POWER SOURCE AT THIS POINT.
4.
Connect the tuner to your preamplifier using a set of cables consistent with
the caliber and type (balanced or unbalanced) of your system. Select the tuner
input on your preamplifier.
Note: Be sure that the preamplifier is set to zero.
5.
Connect the FM antenna and/or cable to the RF input on the back of the unit.
6.
CHECK TO MAKE SURE THE UNIT IS SET UP FOR THE PROPER VOLTAGE
(check for unit’s voltage marked on rear panel) then plug the tuner’s AC power
cord into an AC power source. Be sure to use a continuous power source so
as to allow the stand-by mode feature to function properly. The tuner’s audio
output is muted in the stand-by mode.
7.
The power switch on the rear of the unit must be put in the “on” position
8.
When power is supplied the screen will be black. To turn on the touch screen,
touch it anywhere on the Magnum Dynalab logo, at which time the
Magnum
Dynalab logo and the word “ power” will be displayed.
- 7 -